DCG has been performing transfer simulations as a service for years now in order to collect real world hard data to make the most accurate transfer simulation software available today.
Our Transfer Optimization service uses kinematics to check for crashes and close calls between the dies, transfer system and press. Your entire die is put into motion, including all pads, lifters, and cams, so full functionality can be verified. A Corrective Action Report (CAR) is generated to communicate where changes are needed. Transfer curves can be adjusted and optimized for maximum strokes per minute (SPM). Full motion videos are included to clearly communicate any issues found in simulation. Use Transfer Optimization for design, setup, and production.
Our service will determine the velocity and acceleration rate of the transfer system, and return your maximum SPM. Curves can be easily adjusted and re-analyzed in minutes to optimize motions for the highest production rate. Once optimization is complete, upper and lower interference curves are generated for export to your design source. Address the issues at the beginning of the project instead of worrying about it at the end.